What to do if Ricoh Pro 8100S is unable to connect to the network?
If your Ricoh All in One Printer can't connect to the network, it might be due to a network error. Ensure the printer is correctly connected and properly configured. If issues persist, contact your administrator. If the indicator lamp remains lit after troubleshooting, contact your service representative.
What to do if Ricoh Printer misfeeds frequently?
Frequent misfeeds in your Ricoh Printer can occur due to several reasons. Using curled paper can cause misfeeds, so straighten the paper or load it upside down. Ensure the tray's side or end fences are properly set and locked. Misfeeds may also happen if paper of undetectable size has been loaded or if there's a foreign object on the finisher tray. Lastly, check if the staple cartridge is correctly set.
Why are documents not printing from my Ricoh All in One Printer?
If documents and reports are not printing from your Ricoh All in One Printer, it might be because the paper output tray is full. Remove the prints from the tray. Alternatively, the printer may be out of paper. In this case, load paper into the printer.
Why do misfeeds occur frequently on Ricoh Pro 8100S All in One Printer?
Frequent misfeeds in your Ricoh All in One Printer may be caused by the tray's side or end fences not being set properly. Remove the misfed paper, then check that the side or end fences are correctly set and locked.
Why is the display turned off on my Ricoh All in One Printer?
If the display on your Ricoh All in One Printer is turned off, the machine may be in Low Power mode. Touch the display panel or press a key on the control panel to exit Low Power mode.
Why are original images printed on the reverse side of the paper with Ricoh Pro 8100S?
If original images are being printed on the reverse side of the paper by your Ricoh All in One Printer, the paper may have been loaded incorrectly. Load the paper correctly.
Why is a function not running or cannot be used on my Ricoh Printer?
If a function on your Ricoh Printer does not run or cannot be used, the machine may be in use by another function. Wait until the current job is completed before trying again. Also, the function cannot be performed while the Address Book is being backed up. Wait a while, and when the Address Book backup is complete, the function will be performed.
Why is paper bent when it comes out of my Ricoh Printer?
If paper is bent when ejected from the finisher upper tray of your Ricoh Printer, change the output tray to the finisher shift tray.
What to do if error message remains after removing misfed paper from Ricoh Printer?
If an error message remains on your Ricoh Printer even after removing misfed paper, it could be because the front cover needs to be opened and closed. Also, check if paper is still jammed in the tray. After removing the misfed paper, fully open the front cover and then close it.
What to do if Ricoh Printer shows an error?
If an error has occurred on your Ricoh Printer, and the status "Error Occurred" is displayed in the [Check Status] screen, press [Check] in the function where the error occurred. Check the displayed message and take appropriate action. You can still use other functions normally.
General| Print Resolution | 1200 x 1200 dpi |
|---|---|
| Hard Drive | 320 GB |
| Connectivity | Ethernet, USB |
| Supported Media Sizes | A4, A5, B5, Letter, Legal |
| Duplex Printing | Yes |
| Paper Weight | 52-300 gsm |
| Memory | 2 GB |
| Operating System Compatibility | Windows, macOS, Linux |
| Weight | 90 kg |
To Next Page
