15. Change the Bit Switch Settings back to the default 00000000.
16. Remove the SD card after main power switch is turned off.
Error Messages
Card Save error messages:
• Init error: A card save process (i.e. card detection, change to kernel mode) failed to initialize.
• Card not found: Card cannot be detected in the slot.
• No memory: Insufficient working memory to process the job.
• Write error: Failed to write to the card.
• Other error: An unknown error occurred.
If an error occurs, pressing “#Enter” will cause the device to discard the job and return to the ready state.
Error Messages
Card Save error messages:
• Init error: A card save process (e.g. card detection, change to kernel mode) failed to initialize.
• Card not found: Card cannot be detected in the slot.
• No memory: Insufficient working memory to process the job.
• Write error: Failed to write to the card.
• Other error: An unknown error occurred.
If an error occurs, pressing “#Enter” will cause the device to discard the job and return to the ready state.
Card Save Function
163
To Next Page
Loading...
