Ricoh S-P2 - Page 68

stored, or the data read from the media is
defective.
replace the HDD and initialize with
SP5832.
Note: If you turn off the machine while the
HDD is being accessed, this can damage
the HDD.
872 B
HDD mail receive data error
The machine detected that the HDD
was not operating correctly at power
on.
The machine detected that the HDD
was not operating correctly (could
neither read nor write) while
processing incoming email
• HDD defective.
• Initialize the HDD with SP5832. If this does
not solve the problem, replace the HDD
and initialize with SP5832.
Note: If you turn off the machine while the HDD
is being accessed, this can damage the HDD.
873 B
HDD mail send data error
An error was detected on the HDD
immediately after the machine was
turned on, or power was turned off
while the machine used the HDD.
• HDD defective.
• Initialize the HDD with SP5832. If this does
not solve the problem, replace the HDD
and initialize with SP5832.
Note: If you turn off the machine while the HDD
is being accessed, this can damage the HDD.
874 D
Delete All error 1: HDD
A data error was detected for the
HDD/NVRAM after the Delete All
option was used.
Note: The source of this error is the
Data Overwrite Security Unit B660
running from an SD card.
• Turn the main switch off/on and try the
operation again.
• Install the Data Overwrite Security Unit
again. For more, see section “1.
Installation”.
• HDD defective
875 D
Delete All error 2: Data area
An error occurred while the machine
deleted data from the HDD.
• Turn the main switch off/on and try the
operation again.
4. Troubleshooting
66
4