Ricoh S-P2 - Page 92

1914 [Nip Measure] Fusing Nip Width Measurement
1914 001
Measure Exe.
[0 or 1 / 0 /-]
0: Not execute, 1: Execute
Performs the nip width measurement. This is for by-pass tray and used OHP type.
SP2-xxx: Drum
2001
Charge Rol Bias DFU
Adjusts the voltage applied to the charge roller for printing.
[-2000 to 1000/–1670/10V step]
2112
Mainscan Mag Main Scan Magnification
Adjusts the main scan magnification.
[-0.5% to 0.5%/0/0.1% step]
2113
Subscan Mag Sub Scan Magnification
Adjusts the sub scan magnification.
[-0.5% to 0.5%/0/0.1% step]
2201
Developer Bias
Adjusts the development bias for printing.
[200 to 800/750V/10V step] DFU
2213
Toner End Count
Adjusts the number of prints the machine can make after it detects toner near-end.
[50 to 200/200/50 sheets/step]
2301
Transfer Curr Transfer Current
Adjusts the correction current applied to the transfer roller.
[-4 to +8/0/2 uA /step]
5. Service Tables
90
5