3927
TonerEndJudg
This SP code determines whether the machine disables printing when the machine detects
toner end.
• Even when toner end is detected, there is a small amount of toner left in the AIO. If
a user wants to print with the AIO until all toner is used up, then set this SP to 1. But
then, there is no toner end detection, and the user must watch the print quality and
change the AIO when prints become too pale.
[0 to 1/0/1]
0: Yes (Printing stops when toner end is detected.)
1: No (Printing can continue even after toner end is detected.)
SP5-xxx: Mode
5024
mm/inch Display Selection
Selects the unit of measurement.
After selection, turn the main power switch off and on.
0: Europe/Asia (mm), 1: North America (inch)
5051
Toner Refill Displ Toner Refill Detect Display
This SP switches on/off the message that prompts the operator when it is necessary to
replenish toner in the machine.
0: enable (Message displayed (Default))
1: disable (Message not displayed)
5055
Display IP add Display IP Address
Switches the banner display of the IP address off and on.
[0 to 1/0/1] 0= No, 1= Yes
For example, if this SP is switched on, the IP address will be displayed below "Ready"
while the printer is in standby mode:
Ready
169.254.187.055
5302 Set Time
5. Service Tables
92
To Next Page
Loading...
