4. Enter the length of [X1] with the number keys, and then press [ ].
5. Enter the length of [Y1] with the number keys, and then press [ ].
6. Enter the length of [X2] with the number keys, and then press [ ].
7. Enter the length of [Y2] with the number keys, and then press [ ].
If you want to erase the image on the back side of the original, press [2 Sided Setting] and then [Back].
Erasing the image on the back side is valid when you copy 2-Sided originals.
8. Press [OK].
9. To specify multiple areas, select areas 1 to 5, and then repeat steps 3 to 8.
10. Press [OK].
• To change the value you entered, press the key you want to change, and then enter a new value.
• You can specify up to five areas.
Erase Outside
Use this function to copy the original while erasing outside of a specified area.
To specify the area you want to erase, you have to define the value of X1, Y1, X2, and Y2 on the original.
Measure the area you want to specify before entering the area settings.
Advanced Copier Functions
173
To Next Page
Loading...
