3. Press [OK].
4. Place the originals, and then press the [Start] key.
• When placing an original on the exposure glass, start with the first page to be copied. When placing
originals in the ADF, set so that the first page is on the top.
• You can change the punch hole positions shown on the initial display under Input/Output in User
Tools. For details, see “Copier/Document Server Features”, General Settings Guide.
Z-fold
Makes two parallel folds, one of which faces in and the other facing out.
• You cannot use the bypass tray with this function.
• You cannot use Punch with this function.
Original orientation and Z-fold position
Place all the originals in the ADF in the orientation in which they can be read normally. When placing
the original on the exposure glass, keep the same orientation, but set the original facing downwards.
The relationship between the orientation in which you place the original and the Z-fold positions is as
follows:
Finishing
91
To Next Page
Loading...
