Ricoh SP 112SF - Placing Originals on the Exposure Glass

Placing Originals on the Exposure Glass
• Do not place originals until all correction fluid or toner becomes completely dry. Doing so may
create marks on the exposure glass that will appear on copies.
1. Lift the exposure glass cover.
2. Place the original face down on the exposure glass. The original should be aligned to the
rear left corner.
CXP047
3. Lower the exposure glass cover.
Scanning thick originals
1. Lift the exposure glass cover.
2. Pull up the exposure glass cover and remove it.
CXP009
3. Place the original face down on the exposure glass. The original should be aligned to the
rear left corner.
4. Lower the exposure glass cover.
2. Loading Paper
38