2-36
Confidential
Error code 8A01
The registration rear sensor detected that the paper fed was smaller or larger than the
specified size in duplex printing mode.
<User Check>
• Use appropriate paper (Letter to Legal).
Error code 8C00
There is no paper set in the manual feed slot on the manual feed slot printing.
<User Check>
• Set the paper in the manual feed slot.
Error code 9002
The size of paper loaded in the paper tray and the one specified from the driver are not same
when paper is fed from the paper tray.
<User Check>
• Change the driver setting to be matched with the size of the paper set in the paper tray.
Step Cause Remedy
1
Registration rear actuator caught
in some sections of the machine
Reattach the registration rear actuator.
2 Registration rear sensor failure Replace the actuator holder ASSY.
3 Main PCB failure Replace the main PCB ASSY.
Step Cause Remedy
1
Registration front actuator caught
in some sections of the machine
Reattach the registration front actuator.
2
Connection failure of the
registration front/rear sensor
PCB harness
Reconnect the registration front/rear
sensor PCB harness.
3 Registration front sensor failure Replace the actuator holder ASSY.
4 Main PCB failure Replace the main PCB ASSY.
Step Cause Remedy
1
Registration rear actuator caught
in some sections of the machine
Reattach the registration rear actuator.
2 Registration rear sensor failure Replace the actuator holder ASSY.
3 Main PCB failure Replace the main PCB ASSY.
To Next Page
Loading...
