Message Cause Solution
"Independent-supply toner" Independent-supply toner is
set.
Use the toner recommended
for this printer.
"IPv6 Address already exists Link-
local Address(109/209)"
The same IPv6 address is
already used.
Contact your network
administrator.
"IPv6 Address already exists Stateless
Address(109/209)"
The same IPv6 address is
already used.
Contact your network
administrator.
"IPv6 Address already exists Manual
Config. Address(109/209)"
The same IPv6 address is
already used.
Contact your network
administrator.
"Load paper in (tray name)" There is no paper in the
specified tray.
Load the specified paper in
the tray, press [JobReset] to
reset the job.
"No privileges to use funct." The logged in user does not
have the privileges to register
programs or change the
paper tray settings.
For details about how to set
permissions, see Security
Guide.
"Option RAM Error" The printer cannot detect an
optional SDRAM module.
Check that the SDRAM
module installed correctly.
"Par. I/F board has a problem." The printer's self-diagnostic
test failed due to a loopback
error.
Replace the IEEE 1284
board that caused the error.
"Printer Font Error." There are problems with the
printer's font file.
Turn the printer off, and then
turn it on again.
If the problem persists,
contact your sales or service
representative.
"Problem with Hard Disk Please call
service."
The printer cannot detect the
hard disk.
Check that the hard disk
installed correctly. If the
problem persists, contact
your sales or service
representative.
3. Troubleshooting
76
To Next Page
Loading...
Need help?
General
