Message Cause Solution
"Problem:Wireless card Please call
service."
The printer cannot detect a
wireless LAN interface
board.
Check that the wireless LAN
interface board installed
correctly. If the problem
persists, contact your sales or
service representative.
"Replacmnt Requrd Maint. Kit" You need to replace the
maintenance kit.
For details, see "Replacing
Other Consumables",
Operating Instructions.
"Replcmnt Requrd Drum Unit" You need to replace the
drum unit.
For details, see "Replacing
Other Consumables",
Operating Instructions.
"Repl Requrd Soon Maint. Kit" You will need to replace the
maintenance kit soon.
Contact your sales or service
representative to obtain a
new unit.
"Rplcmnt Rqrd Soon:Drum Unit" You will need to replace the
drum unit soon.
Contact your sales or service
representative to obtain a
new unit.
"SD Card authenticatn.failed Error
recurs, call service."
Authentication from the SD
card failed.
Turn the printer off, and then
turn it on again. If the
problem persists, contact
your sales or service
representative.
"Set the Drum Unit correctly." The drum unit may not be
installed correctly.
Turn the printer off, and then
install the drum unit again.
"Set the Maintenance Kit correctly." The fusing unit may have not
been installed correctly.
Turn the printer off, and then
install the fusing unit again.
If the message continues to
appear after the unit is
installed again, contact your
sales or service
representative.
"Set the Toner Cartridge correctly." The print cartridge may have
not been installed correctly.
Turn the printer off, and
install the print cartridge
again.
When Messages Are Displayed
77
To Next Page
Loading...
Need help?
General
