Ricoh SP 4510 DN User Manual

Message Cause Solution
"84: Error" There is no work area available
for image processing.
• Select [Font Priority] for
[Memory Usage] in
[System]. Decrease the
number of files sent to the
printer.
• Decrease the number of
files sent to the printer or
install the optional SDRAM
module. For details about
installing SDRAM module,
contact your service
representative.
"85: Error" The specified graphics library is
unavailable.
• Check that the data is
valid.
• Decrease the number of
files sent to the printer or
install the optional SDRAM
module. For details about
installing SDRAM module,
contact your service
representative.
"86: Error" Parameters of the control code
are invalid.
Check the print settings.
"91: Error" Printing was canceled by the
auto job cancel function due to
a command error.
Check that the data is valid.
"92: Error" Printing was canceled because
[Job Reset] or the [Suspended]
key was selected on the printer's
control panel.
Perform the print operation
again as necessary.
"98: Error" The printer could not access the
hard disk correctly.
Turn the main power switch off
and then back on again. If the
message appears frequently,
contact your service
representative.
When Messages Are Displayed
89

Ricoh SP 4510 DN Specifications

General

Print Technology	Laser
Resolution	1200 x 1200 dpi
Maximum Paper Capacity	1, 600 sheets
Duplex Printing	Yes
Memory	512 MB
Monthly Duty Cycle	150, 000 pages
Maximum Paper Size	A4
Connectivity	USB 2.0, Ethernet
Media Sizes Supported	A4, A5, A6, B5, B6, Letter, Legal, Executive
PDL	PCL6, PostScript 3
Operating System Compatibility	Windows, Mac, Linux
Paper Capacity	600 sheets (1 x 500-sheet tray + 100-sheet bypass tray)