Cause:
This may occur if:
• Using paper with a rough surface
• Documents with a small image area are printed continuously.
• Printing in a low humidity environment
• Printing in a high humidity environment
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Specifying a Custom Paper", Preparation.
Solution:
Carry out the following sequence of procedures. Terminate the sequence as soon as the problem is
resolved.
(a) Adjust the image density.
1. In the [Machine: Image Quality] group on the [Adjustment Settings for Operators] menu,
select 0201: [Execute Image Quality Adjustment] and execute [Adjust Image Density].
2. Print the image. Has the problem been resolved?
Yes Finished!
No Proceed to "(b) Replacing the parts".
(b) Replacing the parts
1. Check for parts that need replacement.
Yes Replace the necessary parts.
No Proceed to "(c) Adjust the transfer settings".
2. Print the image. Has the problem been resolved?
Yes Finished!
No Proceed to "(c) Adjust the transfer settings".
Uneven Density
65
To Next Page
Loading...
Need help?
General
