• Complete the procedure to return to standby mode, read the number of the error displayed
to determine the cause of the error.
9. Press [Escape] to return to the "2. ENGINE MAINTE." display.
10. Select "3. END" and push [#Enter] to return to standby.
11. Switch the printer off.
12. Remove the cleaning cartridges and store the printer.
• The initial ink fill counter resets at the end of washing. The next time the ink cartridges are installed
and the printer is switched on, the initial filling sequence will begin.
• Do not install the ink cartridges and turn the printer on again after washing until you are ready
to use or service the printer again.
13. Remove the ink collection tank from the back of the printer and discard it.
14. Insert a new ink collection tank.
15. Do SP7200 to reset the software counter for the new ink collection tank.
5. After Repair
62
To Next Page
Loading...
Need help?
General