RiCOMA (Shenzhen) Co.,Ltd
A Passion for Excellence Visit us at
Add.: Building B, ShenChangGang Science Park, Jinlong Road 1, Baolong Industrial Town,
Longgang District, Shenzhen, P.R.C
Tel.:+86-0755-25857576 Fax: +86-0755-25857773 - 10 -
www.ricoma.cn
Auto jump stiches: It means auto jump when stitch length is bigger than the
setting value, with default value 75，meaning auto jump
when stitch length is bigger than 7.5mm; setting range
65—85，meaning6.5mm---8.5mm；
Auto slow speed stiches: It means auto slow speed when stitch length is bigger
than the setting value, with default value 60，meaning
auto jump when stitch length is bigger than 6.0mm;
setting range 40—90，meaning4.0mm---9.0mm；
Principal axis stop position: It is used for fine tune of principal axis stop
position, with default value5 and setting range 0—30；
Maximum speed: With default value 1200, the maximum value than which the
setting value cannot be higher, otherwise poor quality of
embroidery may be caused.
Maximum frame speed: With default value 5 and setting range 1-9
Same color automatic: With default status Yes；
Lower speed with consecutive jumps:
It means it will slow down the speed to
setting percentage of original one during consecutive
To Next Page
Loading...
