18
Components information
Once the software is connected to the VCU the software will show the
components connect on the system, if one or more components don’t are
connected means a CAN issue, on this step the software don’t has the full
information of these components.
To have the full information of the different components (status of components,
errors, etc.) is necessary click on each tab of each component. If one tab is not
clicked we will not obtain the information of this component.
On each tab we found DTC Reset button when we push this button we erase
the historic errors of the component selected, this operation is necessary do on
each component with errors.
If we can’t erase the error mans that it continues active on the bike and is
necessary repair it on the bike.
To Next Page
Loading...