Rigol DM3000 Series - Page 59

RIGOL
© 2007 RIGOL Technologies, Inc.
User‟s Guide for DM3000 Series
2-9
Basic measurement:
1. Connect test leads shown in Figure 2- 6; red test leads to the HI Terminal, black
test leads to the LO Terminal.
2. Press to select the DC Voltage measurement function.
3. Choose the appropriate measurement range.
4. Set up the DC Ratio Measurement.
Press  Ratio  On, to start the DC Ratio Measurement.
5. Lead test leads into circuit, start to measure.
Figure 2- 6 Ratio Measurement
Signal
Voltage
Reference
Voltage