Example 5: P/F Test
P/F Operation hints you the signal is overstep its range according to the selected
High/Low Limit parameters; meanwhile the buzzer makes a sound to alarm (if
Sound is open)
Operating Steps:
1. Press
button to start AC Voltage Measurement and choose an appropriate
voltage range.
2. Connect test leads as Figure 2-8.
3. Set the High/Low Limit Value.
(1) Press P/F High to set the high limit value.
Figure 3-9 Set the High Limit Value
(2) Press P/F Low to set the low limit value.
Figure 3-10 Set the Low Limit Value
(3) Press ON to start P/F tesing. As shown in Figure 3-11, The test result is
“PASS” as the measured value is between 0V and 1V.
Figure 3-11 P/F Test result
w ww. . com
information@itm.com1.800.561.8187
To Next Page
Loading...
