Power On
Power on the instrument according to the following steps:
1. Adjust AC Voltage Selector to “115” (100~120V, 45~440Hz, AC) or “230”
(200~240V, 45~60Hz, AC) in accordance with power standards in your country;
2. Connect the instrument to AC supply via power cord supplied by RIGOL;
3. Turn on the power switch on the rear panel;
4. Press the power key
[1]
on the front panel, the instrument will be started a few
seconds later.
Note
[1]
: Press System
[2]
Cfg Switch OFF to disable the power key,
so as to start the instrument after turning on the power switch on the rear panel.
Note
[2]
: The characters listed under shading indicate menu in the multimeter.
w ww. . com
information@itm.com1.800.561.8187
To Next Page
Loading...
