Single Triggering
The multimeter takes one reading, or a number of readings specified by a sample
count you enter, each time press
.
Press Single to enter into the following interface. Then Input needed sample
counts by Direction keys. After setting please press Done to open Single Trigger, at
this time Done is hiding and is lighten.
Figure 2-69 Settings of sample count
Sample Count indicates the count of point sampled while the instrument
getting a signal of Single Trigger.
The range of sampling point should be between 1 and 2000.
The default of Sample Count is 1.
w ww. . com
information@itm.com1.800.561.8187
To Next Page
Loading...
