RIGOL
User’s Guide for DM3058/DM3058E
Relative Operation
Relative operation is used for relative measurement. Actual measurement reading is
the depression between measurement value and preset value.
Press REL to enter into the following interface.
Figure 2-65 Relative operation setting interface
Table 2-20 REL operation function menu
Function Menu Settings Explanation
Current
To select current measurement value as
preset value.
Clear Reposition the preset value to 0.
On/Off
Open/Close this function. When opening,
“REL” will be shown.
Save all the changes and go back to last
menu.
Main display = Measurement value –preset value
The Multimeter allows operating for following parameters: DC Voltage, AC Voltage,
DC Current, AC Current, Resistance, Frequency/Period, Capacitance and Sensor.
on the operating interface directly to enter into the
“Preset Value” setting interface.
Select Current, press On/Off to start REL operation, and then the
readings in current set will be stored as a reference value.
Users can input needed preset value by direction keys in the
corresponding setting interface.
w ww. . com
information@itm.com1.800.561.8187
To Next Page
Loading...
