Chapter 2 Front Panel Operations RIGOL
User’s Guide for DM3068
To Set the Configuration
Press System Cfg to enter the following interface.
1. PwrOn
Select a system configuration to be used at power-on from “Default” and
“Last” (configuration at last power-off).
This setting will be available at the next power-on.
The multimeter will always use DCV as the default measurement at every
power-on no matter Default or Last is selected.
2. Default
Restore the multimeter to factory defaults (see Table 2-8).
3. Switch
Enable or disable the front power button. The default status is OFF.
ON: enable the front power button. After turning on the power switch at
the rear panel, users need to press the power button at the front panel to
turn on the multimeter.
OFF: disable the front power button. Users can directly start the
multimeter by turning on the power switch at the rear panel. However,
you can still turn off the multimeter by pressing the power button at the
front panel.
Table 2-8 Factory defaults
Parameter Factory Default
*Short-circuit Resistance 10 Ω
AC Filter Mid
DC Input Impedance 10 MΩ
Reading Resolution 6 ½
Measurement Function DCV
To Next Page
Loading...
