Rigol DS1000CA Series - Page 83

Programming Introduction RIGOL
Programming Guide for DS1000CA Series
2-71
:KEY:CURSor
Function Explanation:
This command is used to set the on-state for cursor function and its menu.
Repeating the command would make the cursor switched between four cursor
modes.
16. :KEY:ACQuire
Command Format:
:KEY:ACQuire
Function Explanation:
This command is used to set the on-state for acquire function and its menu.
Repeating the command would make the acquisition switched between ON
and OFF.
17. :KEY:DISPlay
Command Format:
:KEY:DISPlay
Function Explanation:
This command is used to set the on-state for display function and its menu.
Repeating the command would make the display switched between ON and
OFF.
18. :KEY:STORage
Command Format:
:KEY:STORage
Function Explanation:
This command is used to set the on-state for storage function and its menu.
Repeating the command would make the storage switched between ON and
OFF.