Rigol DS1000CA Series - Page 84

RIGOL Programming Introduction
Programming Guide for DS1000CA Series
2-72
19. :KEY:UTILity
Command Format:
:KEY:UTILity
Function Explanation:
This command is used to set the on-state for utility function and its menu.
Repeating the command would make the utility switched between ON and
OFF.
20. :KEY:MNUTIME
Command Format:
:KEY:MNUTIME
Function Explanation:
This command is used to set the on-state for horizontal system and its
menu. Repeating the command would make this function switched between
ON and OFF.
21. :KEY:MNUTRIG
Command Format:
:KEY:MNUTRIG
Function Explanation:
This command is used to set the on-state for trigger system and its menu.
Repeating the command would make this function switched between ON and
OFF.
22. :KEY:Trig%50
Command Format:
:KEY:Trig%50
Function Explanation: