Rigol DS1000CA Series - Page 85

Programming Introduction RIGOL
Programming Guide for DS1000CA Series
2-73
The command is used to set the trigger level to the vertical midpoint of the
signal amplitude.
23. :KEY:FORCe
Command Format:
:KEY:FORCe
Function Explanation:
This command is used to release the remote control.
24. :KEY:V_POS_INC
Command Format:
:KEY:V_POS_INC
Function Explanation:
This command is used to move the waveform display up gradually.
25. :KEY:V_POS_DEC
Command Format:
:KEY:V_POS_DEC
Function Explanation:
This command is used to move the waveform display down gradually.
26. :KEY:V_SCALE_INC
Command Format:
:KEY:V_SCALE_INC
Function Explanation:
This command is used to increase the vertical scale of the current channel
with the 1-2-5 step sequence.