Rigol M300 - Page 24

RIGOL
M300 Quick Guide
16
5. MC3264 (64-Channel Single-Ended Reed Multiplexer)：
64-channel single-ended reed multiplexer.
MC3264 is applicable to high-speed scan and high-throughput auto test
applications. All 64 channels can switch HI input only. MC3264 is divided into
two banks (A and B) of 32 single-ended channels each. All channels are
break-before-make. In any case, you cannot close multiple channels on this
module. This module can be connected with MC3065 (DMM Module, if MC3065
is currently inserted) but cannot be used for 4-wire resistance measurement. For
the specifications of this module, please refer to the User’s Guide or Data Sheet
of this product.
6. MC3324 (24-Channel Multiplexer)：
Mix multiplexer with 20 voltage channels and 4 current channels.
All 20 voltage channels switch both HI and LO inputs, thus providing fully
isolated inputs to the DMM module, and is divided into two banks (called A and B)
of 10 two-wire channels each. When making 4-wire resistance measurement,
the instrument automatically pairs channels of A bank and B bank. All channels
are break-before-make. You can close multiple channels on this module only if
you have not configured any channel to be part of the scan list.
4 current channels are used in combination with the DMM module to measure
DC current or AC current. All channels are break-before-make. In any case, you
cannot close multiple channels on this module. This module can be connected
with MC3065 (DMM Module, if MC3065 is currently inserted). For the
specifications of this module, please refer to the User’s Guide or Data Sheet of
this product.
7. MC3416 (16-Channel Actuator)：
16-channel actuator.
MC3416 can connect signal to the device under test or enable external device.
Any of the 16 channels can switch to Normally-Open (NO) and Normally-Closed
(NC) states. For the specifications of this module, please refer to the User’s
Guide or Data Sheet of this product.
8. MC3534 (Multifunction Module)：
Multifunction module.
It provides 3 kinds of functions with 4 channels for each function. This module
can be used to check status or control external device (such as the solenoid,
power relay and microwave switch). You can also read digital inputs and the
totalizer count during a scan.
 Four 8–bit digital input/output (DIO) ports
 4 totalizer (TOT) input terminals (the first two channels are 10 MHz TOT and
the other two channels are 100 kHz TOT) with 1 Vpp sensitivity
 4 analog output terminals, ±12 V calibrated voltage
For the specifications of this module, please refer to the User’s Guide or Data
Sheet of this product.