Rinda Technologies TechMate Pro - 2001-2006 115 hp EFI 4-Cycle ECM; Connecting to 115 hp EFI Engines

2001 - 2006 115hp EFI 4-Cycle
Page 50
Figure 32 2001 - 2006 115hp EFI 4-Stroke ECM
Mercury’s 2001 thru 2006 115hp EFI 4-cycle engines with Yamaha powerheads
are supported by the scan tool. is system is equipped with a 2-connector
Mitsubishi-designed control module as shown in the photo above.
Connecting to the engine.
e scan tool provides an variety of diagnostic and support functions for trou-
bleshooting engines equipped with this EFI system. Connection and operation of
the tool is simple and straight forward.
3-pin Adapter
Rinda Tech P/N 94038
1) Locate the engine’s 3-pin diagnostic link connector (DLC).
2) With the engine’s ignition switch in the OFF position, plug the scan tool’s
communication cable into the diagnostic connector. Scan tool adapter #94038
is required for this application.
3) Once connected, turn the ignition switch ON and start the engine if
necessary.