Table 11: Networker Error Codes
Error Code Potential Cause / Remedy
These errors indicate that an overheat condition has occurred on the heater. The heater's fan will
be forced to operate at maximum speed.
1.
Check there are sufficient outlets or zones open
2.
Check that the floor/ceiling register and balancing damper is not restricting air movement
3.
Check the return air filter (if fitted) is sized correctly, clean and no obstructions have been
placed in front of the return air intake
1.
Check the gas supply is turned ON at the meter, and at the appliance gas cock
2.
Check if other gas appliances are operating such as Gas Cooker and Hot Water Service (if
installed)
3.
Check the gas cylinders have gas, and the cylinder valve is open (LPG only)
4.
Check that there is gas supply to your home. Contact your gas provider to confirm this. There
may be works in your area or a problem with the supply
5.
The heater may require a general service
This error indicates the heater has locked out after 4 ignition attempts. This error can be reset
using the “Reset” button to restart the heater, but the unit may lockout again if the condition has
not been rectified (see 6.1).
1.
Refer checklist for error 46, 47 & 55.
Error 56 indicates a lockout has occurred on the heater combustion fan pressure switch, usually
caused by too much restriction on the flue pipe or condensate drain on condensing furnaces.
1.
Check the flue pipe for Blockages
2.
Check the condensate piping for Blockages
Any other Error Codes that appear on the screen could indicate the system is not operating due to a malfunction or fault with an electronic
control module. This error may be reset at the power supply.
If the fault continues to appear, promptly contact Brivis with the error code, model and serial number of your system.
To Next Page
Loading...