Rinnai brivis ZonePlus - Zoneplus System Configuration - Summary

5
1.2 ZonePlus System Configuration -
Summary
Below is a summary of your system’s configuration. A detailed
version of this table (located in the Appendix) should also be
completed by your installer and retained for future reference.
Table 2: System Configuration Summary
ZONE
SENSOR TYPE^^
(NC-6 / NT-1)
ZONE A
ZONE B
ZONE C
ZONE D
COMMON
(If applic)
--
CONSTANT
(MTSP - If applic)
--
ZONE: A B C D NIL
(circle one only)
^^NC-6 Master Controller displays 'Clock' indicator when OFF.
^Zoning is not available during Evaporative Cooling mode.
Maximum no. of Zones for HEATING:
Max. no. of Zones for REFRIGERATED COOLING:
ROOM(S)
ZONEPLUS SYSTEM CONFIGURATION - TO BE COMPLETED BY INSTALLER
HEATING ONLY

DUAL COMFORT

HEATING & EVAPORATIVE COOLING^

MULTI TEMPERATURE SET POINT 
SINGLE TEMPERATURE SET POINT 
SYSTEM DESIGN CONDITIONS