Rinnai infinity 32 HD 250 E - OPERATION WITH STANDARD TEMPERATURE CONTROLLERS

- 10 -
OPERATION WITH STANDARD TEMPERATURE CONTROLLERS
Using the Infinity with 1 Standard Temperature Controller
Press the ON/OFF button on the Temperature Controller.
The yellow ON indicator will glow on the
Temperature Controller. This indicates that the hot
water unit is ready to supply hot water when a tap
is open.
To operate the hot water unit, simply turn any hot
water tap on. This will automatically light the
burner providing hot water. The red IN USE
indicator will glow on the Temperature Controller.
Adjusting Temperature
Simply press the HOTTER ∧ or COOLER ∨
button until the required temperature is displayed
on the Digital Monitor.
CHECK WATER TEMPERATURE BEFORE USE.
A parent should always check the temperature before a child is placed in contact with hot water
.
CAUTION
When any hot water tap is open, temperature cannot be adjusted except between 37°C and 43°C.
For safety reasons, temperature ‘priority’ cannot be transferred between controllers when a hot
water ta
p
is o
p
en
NOTE