Rishabh RISH Master 3440 - 3.2.4.1.1.1.3 Pulse Rate

Pressing “ Up” key accepts the presents value
and advances to the “Configuration of Output”
(See section 3.2.4.1).
Pressing the “ Down” key will enter the “Pulse rate
divisor Edit” mode and scroll the value through the values
1,10,100,1000 wrapping back to 1 in Wh but in KWh &
MWh pulse rate divisor is only 1.
Pressing the “ Up” key advances to the “Pulse rate
Divisor Confirmation” menu.
VYB
VRY
KVAr
Sys
V
A
KVA
Min
KW
VBR
Angle
Max
x1000
KVArh
x1000
x1000
IN
Ph R
Hz
KVAh
Ph Y
P.F.
KWh
Ph B
KAh
%THD
Demand
For setting divisior value refer table 3.
VYB
VRY
KVAr
Sys
V
A
KVA
Min
KW
VBR
Angle
Max
x1000
KVArh
x1000
x1000
IN
Ph R
Hz
KVAh
Ph Y
P.F.
KWh
Ph B
KAh
%THD
Demand
(See section 3.2.4.1)
Pulse Rate Divisor Confirmation.
This screen will only appear following an edit of the
Pulse rate divisor.
If the Pulse rate shown is not correct, pressing the
“ Down” key will return to the “Pulse rate divisor
Edit” stage by blanking the bottom line of the
display.
Pressing “ Up” key sets the displayed value and
will advance to the “Configuration of output”.
3.2.4.1.1.2.1 Assignment of Parameter to Limit output (for Relay1)
This screen is for Limit output mode selection. It allows the user to set Limit output corresponding
measured value . Refer Table 2“ Parameter for Analog & Limit output “ for assignment.
38