Rishabh RISH Master 3440 - 3.2.4.1.1.2.1 Assignment of Parameter to Limit output (for Relay1)

Pressing “ Up” key accepts the present value and
advance to the Limit1 configuration select screen.
Pressing the “ Down” key will enter the “ Limit1
output Edit” mode and scroll the values, as per Table 2,
“ Parameter for Analog & Limit Output”
Pressing the “ Up” key advance to the Limit1 output
confirmation screen .
(see section 3.2.4.1.1.2.2 ).
V
x1000
VRY
KVAr
KVArh
IN
Sys
Ph R
KAh
A
x1000
VYB
KVA
Hz
KVAh
Min
Ph Y
Demand
KW
x1000
VBR
Angle
P.F.
KWh
Max
Ph B
Max Demand
V
x1000
VRY
KVAr
KVArh
IN
Sys
Ph R
KAh
A
x1000
VYB
KVA
Hz
KVAh
Min
Ph Y
%THD
KW
x1000
VBR
Angle
P.F.
KWh
Max
Ph B
Demand
V
x1000
VRY
KVAr
KVArh
IN
Sys
Ph R
KAh
A
x1000
VYB
KVA
Hz
KVAh
Min
Ph Y
Demand
KW
x1000
VBR
Angle
P.F.
KWh
Max
Ph B
Max Demand
V
x1000
VRY
KVAr
KVArh
IN
Sys
Ph R
KAh
A
x1000
VYB
KVA
Hz
KVAh
Min
Ph Y
%THD
KW
x1000
VBR
Angle
P.F.
KWh
Max
Ph B
Demand
Pressing the “ Down” key will re-enter the “ Limit1
output Edit” mode.
Limit1 output Confirmation :
Pressing the “ Up” key sets the displayed value and
will advance to the Limit1 Configuration select screen
( see section 3.2.4.1.1.2.2 )
3.2.4.1.1.2.2 Limit1 Configuration select
This screen is used to set the Limit1 Configuration, four different types of configuration can
H i - E (High Alarm & Energized Relay)
H i - d (High Alarm & De-Energized Relay)
L o - E (Low Alarm & Energized Relay)
L o - d (Low Alarm & De-Energized Relay)
(For detail refer to section 9.2)
selection” screen (see section 3.2.4.1.1.2.3)
Pressing the “ Up” key accepts the present value and
advances to the “Trip point
be selected
39