Replacing and Disposing Consumables
Replacing the Master Roll
52
Replacing the Master Roll
When the entire Master Roll is consumed, the Replace Master Roll Indicator lights. Replace with a new Master Roll.
Important!:
• For the Master Roll, it is recommended to use the products specified by RISO.
• Before replacing the Master Roll, turn the machine on.
1
Open the Master Making Unit Cover.
Lift and open the Master Making Unit Cover by
holding the Master Making Unit Cover Handle.
2
Press the Master Set Lever to
remove the depleted master core.
Note:
• Dispose the depleted Master Roll according to
the disposal rule of your local community.
)p.56
3
Install a new Master Roll.
Remove the shrink-wrap (transparent film) from
the new Master Roll (Do not remove the wrapper
yet.), and place the roll so that the mark on the
master core comes to the front.
4
Insert the leading edge of the Master
Roll into its entrance under the Mas-
ter Guide.
Insert the leading edge under the Master Guide
(green section) until it steps.
Make sure the master passes under the sensor.
KZ30_UG.book Page 52 Monday, December 21, 2009 11:11 AM
To Next Page
Loading...
