Riso SF5 Series - Page 58

56
Chapter 2 Working with the Printer Driver
56
Chapter 2 Working with the Printer Driver
0
IDprint
C
Not displayed in the SF5 Series.
The data will be output as “ID print” when this check box is selected. For ID print, the input of PIN code is required
when printing the data from the printer. Use this setting to print documents you do not want others to read, such as
condential documents.
Though the job is sent to the printer, the master or prints are not made until authorization is input from the printer’s
control panel.
B
WiththePrinterDriverforUSBFlashDrive,placingacheckmarkinthe[USBprint]checkboxautomaticallysets
[USBprint(Manual)]for[Output](
A
44).[USBprint(Autoprocess)]cannotbeselected.
B
Beforesetting[IDprint],maketheauthorizationsettingsintheprinter.Fordetails,seetheprinteruser’sguide.
ID
Input your ID Number registered with the printer.
B
IDs are allocated to each individual user in the range from 0 to 99. For details, ask the administrator of the printer.
a
ActivatetheCondentialmodeafterjobcompletes
You can prevent your condential documents from being duplicated without your knowledge by selecting this check
box. When this check box is selected, the remaining master is automatically replaced with a blank one after all
specied print jobs are nished.
b
Outputthedataafterinitializingprinter
Your RISO printer is initialized before receiving print data when this check box is selected. It is recommended to
select this check box in most cases.