32 • Chapter 4: Display Mode HS-04 Operator’s Manual
4. Press and release POWER MODE to save the User ID and return to the USER ID screen in
Display Mode.
Changing the Station ID (STN ID)
This screen only appears if DISP.SET in User Mode is set to ON (factory setting) and if ID DISP
in Maintenance Mode is set to ON (factory setting is OFF).
Use this screen to select a station ID from the 128 station IDs that are stored in the HS-04’s
memory. Before a station ID is selected on a brand new instrument, the station ID is
“----------”. The factory-installed station IDs have a “S_ID_XXX” format.
The station ID provides a way to identify the HS-04 location during a data logging session.
User IDs can only be selected in this menu item. In order to edit the 128 user IDs, you must use
the 04 Series Datalogging Program or 04 Series Setup Program.
1. After entering Display Mode, press and release POWER MODE until the STN ID screen
sequence appears.
2. To change the Station ID, press and release AIR. The current Station ID flashes.
3. Use AIR to scroll to the desired Station ID.
4. Press and release POWER MODE to save the Station ID and return to the STN ID screen in
Display Mode.
STN
ID
S_ID_001
STN
ID
CHG / AIR
STN
ID
NO /MODE
To Next Page
Loading...
