HS-04 Operator’s Manual Chapter 1: Introduction • 9
About this Manual
The HS-04 Operator’s Manual uses the following conventions for notes, cautions, and warnings.
NOTE: Describes additional or critical information.
CAUTION: Describes potential damage to equipment.
WARNING: Describes potential danger that can result in injury or death.
Safety/
Regulatory
• ATEX: Certificate Number DEKRA 19ATEX0097
II 1G Ex ia IIC T4 Ga (with alkaline batteries)
II 1G Ex ia IIC T3, Ga (with Ni-MH batteries)
• IECEx: Certificate Number IECEx DEK 19.0059
Ex ia IIC T4 Ga (with alkaline batteries)
Ex ia IIC T3 Ga (with Ni-MH batteries)
• QPS classified, “C/US”, as Intrinsically Safe. Exia. Class I, Groups A, B, C, & D.
Instrument
Power
Information
• Operating Voltage: 3.0V
• Operating Current: 1.0 mA
• Operating Power: 3.0 mW
Power Supply
2 AAA alkaline batteries; 1.5V, 1.175 AH (Duracell MN2400 or PC2400)
OR
2 AAA Ni-MH batteries; 1.2V, 800 mAH (Panasonic Eneloop BK-4MCC)
Continuous
Operating
Hours @ 25 °C
Alkaline Batteries: 9,000 hours in Measuring Mode (Non Alarm Operation, Fully
Charged)
Ni-MH Batteries: 6,000 hours in Measuring Mode (Non Alarm Operation, Fully
Charged)
Case
High-impact Plastic, RF Shielded, Dust and Weather Proof (IP67)
Standard
Accessories
• Alligator clip
• Rubber boot
Optional
Accessories
• Belt clip
• Wrist strap
• Calibration cup
• Datalogging and Setup Programs (Windows
®
7, 8, and 10), available at
www.rkiinstruments.com/04series
• IrDA/USB Cable for connecting to a computer when using the Datalogging and
Setup Programs (not needed if computer has an infrared port)
Dimensions
and Weight
Approximately 67(H) x 54(W) x 24(D) mm (2.6”H x 2.1”W x 0.9”D)
Approximately 93 g (3.3 oz.)
To Next Page
Loading...
