RKI Instruments HS-04 - Page 55

HS-04 Operator’s Manual Chapter 5: User Mode and Calibration • 55
3. Use AIR to display the desired setting.
4. Press and release POWER MODE to save the setting and return to the CAL.RMDR item in
the CAL SET menu.
5. See “Exiting the CAL SET Menu” on page 56 to return to User Mode.
CAL.INT
This setting defines the amount of time between calibrations and can be set in 1 day increments.
The minimum setting is 1 day and the maximum setting is 1000 days. The factory setting is 90
days.
1. After entering the CAL SET menu, press AIR to scroll to CAL.INT.
2. Press and release POWER MODE. The current setting flashes.
3. Use AIR to display the desired setting.
4. Press and release POWER MODE to save the setting and return to the CAL.INT item in the
CAL SET menu.
5. See “Exiting the CAL SET Menu” on page 56 to return to User Mode.
CAL.EXPD
This item defines what indicator is given during start up when calibration is due and CAL.RMDR
is set to ON (factory setting).
CONFIRM (factory setting): The HS-04 gives an indicator at start up if calibration is past due.
Press and release AIR to continue without calibrating or press and release POWER MODE to
enter User Mode and perform a calibration.
CANT.USE
: The HS-04 gives an indicator at start up that calibration is past due. Press and
release POWER MODE to enter User Mode and perform a calibration. Pressing AIR has no
effect. A successful calibration must be performed in order to use the instrument.
NONE: The HS-04 gives an indicator at startup that calibration is past due. It is not necessary to
acknowledge the indicator. If desired, press POWER MODE to enter User Mode and perform a
calibration. The warm-up sequence continues on its own.
1. After entering the CAL SET menu, press AIR to scroll to CAL.EXPD.
CAL .INT
CAL .EXPD