RKI Instruments SP-220 TYPE F - 5 Display Mode; Entering the Display Mode

- 26 -
5
5. Display Mode
5-1. Entering the display mode
This mode allows users to view and change various display settings and perform other operation.
(Display example: For city gases)
1
In the detection mode, press the
MODE button.
The detector enters the peak value display in the
display mode.
2
Next, press the MODE button to
display the appropriate menu.
The setting screen for the display mode is
switched every time the button is pressed.
Holding down the button also switches the
setting screen. When the detector returns to the
detection mode, the setting screen stops being
switched.
3
Select the setting item and press
the POWER button.
For setting items, see "Display mode overview"
on page 27.
NOTE
• The detector automatically returns to the detection mode in about 20 seconds if the detector is left
unoperated.
• Gas detection is continued in the display mode and an alarm can be activated.