12
3.6. Replacing rotating gobos
Disconnect the xture from mains before gobo replacing.
1. Disconnect the xture from mains and allow it to cool.
2. Remove the plastic cover of the head by loosening the 4 quarter-turn fasteners on the cover.
3. Gently pull up the gobo holder from the rotation gobo wheel
.
4. Carefully remove the spring gobo-lock and gobo from the gobo holder.
Do not touch the surface of the pattern
of the glass gobo - use a suitable glove. Be careful! Glass gobo!
5. Insert the new gobo (glazy side towards the LED source). Insert the spring-gobo lock to secure it in
the gobo holder.
6. Insert the gobo holder back into rotating gobo wheel
.
7. Replace the head cover before applying power.
To Next Page
Loading...
