Robe Painte - Replacing the Fuse; Checking Plastic Parts of the Fixture; Disposing of the Product

38
10.1 Replacing the fuse
Before replacing the fuse, unplug mains lead!
1. Remove the fuse holder on the rear panel of the base with a tting screwdriver from the housing
(anti-clockwise).
2. Remove the old fuse from the fuse holder.
3. Install the new fuse in the fuse holder (only the same type and rating).
4. Replace the fuseholder in the housing and x it.
10.2 Checking plastic parts of the xture
The plastic parts of the xture should be checked for damages and beginning cracks at least every two months.
If hint of a crack is found on some plastic part, do not use the xture until the damaged part will be replaced.
Cracks or another damages of the plastic parts can be caused by the xture transportation or manipulation
and also ageing process may inuence plastic materials.
This checking is necessary for both xed installations and preparing xtures for renting. Any free moving parts
inside of the xture or any cracked plastic not sitting properly in place need to be immediately replaced.
10.3 Disposing of the product
To preserve the environment please dispose or recycle this product at the end of its life according to the local
regulations and codes.