32
Colour Wheel Error (Colour Wheel Error 2)
The messages will appear after the reset of the colour wheel if this wheel is not located in the default position.
Prism Error 1 (Prism Error 2 )
The messages will appear after the reset of the prism wheel if this wheel is not located in the default position.
Iris Error 1 (Iris Error 2 )
The messages will appear after the reset of the iris if the iris is not located in the default position.
Frost Error 1 (Frost Error 2 )
The messages will appear after the reset of the frost module if this module is not located in the default position.
Zoom Error 1 (Zoom Error 2 )
The messages will appear after the reset of the zoom module if the zoom lens is not located in the default position.
Focus Error 1 (Focus Error 2 )
The messages will appear after the reset of the focus module if the focus lens is not located in the default.
Gobo Carousel Error 1 (Gobo Carousel Error 2 )
The messages will appear after the reset of the rotating gobo wheel if this wheel is not located in the default
position.
Gobo Rotation Error 1 (Gobo Rotation Error 2 )
The messages will appear after the reset of the rotating gobo wheel if the rotating gobos are not located in the
default positions.
Static Gobo Error 1 (Static Gobo Error 2 )
The messages will appear after the reset of the static gobo wheel if this wheel is not located in the default position.
Fr. Shutters Rot. Error 1 (Fr. Shutters Rot. Error 2 )
The messages will appear after the reset of the framing shutters module if this module is not located in the
default position.
Fr. Shutter 1 Error 1 (Fr. Shutter 1 Error 2 )
The messages will appear after the reset of the framing shutters module if the frame 1 is not located in the
default position.
Fr. Shutter 2 Error 1 (Fr. Shutter 2 Error 2 )
The messages will appear after the reset of the framing shutters module if the frame 2 is not located in the
default position.
Fr. Shutter 3 Error 1 (Fr. Shutter 3 Error 2 )
The messages will appear after the reset of the framing shutters module if the frame 3 is not located in the
default position.
Fr. Shutter 4 Error 1 (Fr. Shutter 4 Error 2 )
The messages will appear after the reset of the framing shutters module if the frame 4 is not located in the
default position.
EEprom Error
Hardware error of the EEprom.
Recharge The battery
The battery on the display board needs to be charged. Let the xture on for cca 6 hrs.
Battery Faulty. Replace it.
The battery on the display board is exhausted and should be replaced immediately.
Pan/Tilt EMS Cal. Error
The EMS system is not calibrated.
Pan/Tilt EMS Error
Control electronics cannot communicate with the EMS system.
To Next Page
Loading...
