8
Truss installation
1. Bolt each clamp (1) to the omega holder (2) with M12 bolt and lock nut through the hole in the holder.
2. Fasten the omega holders to the bottom of the base by inserting both quick-lock fasteners (1) into
the holes of the base and tighten fully clockwise.
3. Clamp the xture on a truss (3) and tighten the rigging clamps.
4. Pull a safety wire (5) through the carrying handle and the truss (3) as shown on the picture above in a suitable
position so that the maximum fall of the xture will be 20 cm. Fasten a snap hook in the attachment point (6).
Use only the safety wire with snap hooks with screw lock gates.
1-Quick-lock fastener
2-Omega holder
3-Trust
4-Clamp
5-Safety wire with snap hooks
with screw lock gates
6-Attachment point
When installing xtures side-by-side, avoid illuminating one xture with another!
To Next Page
Loading...
