36
Fr. Shutters Rot. Error 1 (Fr. Shutters Rot. Error 2 )
The messages will appear after the reset of the framing shutters module if this module is not located in the
default position.
Fr. Shutter 1 Error 1 (Fr. Shutter 1 Error 2 )
The messages will appear after the reset of the framing shutters module if the frame 1 is not located in the
default position.
Fr. Shutter 2 Error 1 (Fr. Shutter 2 Error 2 )
The messages will appear after the reset of the framing shutters module if the frame 2 is not located in the
default position.
Fr. Shutter 3 Error 1 (Fr. Shutter 3 Error 2 )
The messages will appear after the reset of the framing shutters module if the frame 3 is not located in the
default position.
Fr. Shutter 4 Error 1 (Fr. Shutter 4 Error 2 )
The messages will appear after the reset of the framing shutters module if the frame 4 is not located in the
default position.
EEprom Error
Hardware error of the EEprom.
Recharge The battery
The battery on the display board needs to be charged. Let the xture on for cca 6 hrs.
Battery Faulty. Replace it.
The battery on the display board is exhausted and should be replaced immediately.
Pan/Tilt EMS Cal. Error
The EMS system is not calibrated.
Pan/Tilt EMS Error
Control electronics cannot communicate with the EMS system.
Internal Error 1
Communication error between PCBs (error or noise was detected on communication wires)
Internal Error 2
Communication error (some PCB has failed or is disconnected (this PCB will show as N/A in menu --> Infor-
mation --> Software versions) or error/noise was detected on communication wires)
Clean Air Filters
The message informs you that the item "Elapsed Time" in the "Fixture Information" menu is at 0 value. Clean
air lters and reset this counter.
Overheated
The LED engine is overheated and light output is closed.
Base Fan Bad
One or both fans in the xture base are disconnected from their control PCB or are faulty and has to be replaced. .
Fan 1 Bad/Fan 2 Bad/Fan 3 Bad
The suction fan 1 (fan 2/ fan 3) at the LED engine is disconnected from its control PCB or is faulty and has to
be replaced.
Fan 4 Bad/ Fan 5 Bad/ Fan 6 Bad
The exhaust fan 4 (fan 5/ fan6) at the LED engine is disconnected from its control PCB or is faulty and has to
be replaced.
To Next Page
Loading...
