Robe Robin Esprite - Maintenance and Cleaning; General Cleaning and Maintenance; Replacing the Fuse and Checking Parts

44
11. Maintenance and cleaning
It is absolutely essential that the xture is kept clean and that dust, dirt and smoke-uid residues must not build
up on or within the xture. Otherwise, the xture‘s light-output will be signicantly reduced. Regular cleaning will
not only ensure the maximum light-output, but will also allow the xture to function reliably throughout its life.
A soft lint-free cloth moistened with any good glass cleaning uid is recommended, under no circumstances
should alcohol or solvents be used!
DANGER !
Disconnect from mains before starting any
maintenance work
The front objective lens will require weekly cleaning as smoke-uid tends to building up residues, reducing the
light-output very quickly. The cooling-fans should be cleaned monthly.
The interior of the xture should be cleaned at least annually using a vacuum-cleaner or an air-jet.
Gobo wheels and the internal lenses should be cleaned monthly.
Remove dust and dirt from the fans and cooling vents using a soft brush and vacuum-cleaner.
Important! Check the air lters periodically and clean before they become
clogged!
Clean the air lters placed in the base. Use a vacuum cleaner, compressed air or you can wash them and put
back dry.
After replacing the air lters, reset the elapsed time counter in the menu "Information"
(Information--->Air Filters---> Elapsed Time).
Replacing the fuse.
Before replacing the fuse, unplug mains lead.
1. Remove the fuse holder on the rear panel of the base with a tting screwdriver from the housing
(anti-clockwise).
2. Remove the old fuse from the fuse holder.
3. Install the new fuse in the fuse holder (only the same type and rating).
4. Replace the fuseholder in the housing and x it.
Checking plastic parts of the xture.
The plastic parts of the xture should be checked for damages and beginning cracks at least every two months.
In addition, the plastic part of the front lens has to be checked mechanically (by means of movement by the
plastic part) if it is rmly fastened to the xture. If hint of a crack is found on some plastic part, do not use the
xture until the damaged part will be replaced.
Cracks or another damages of the plastic parts can be caused by the xture transportation or manipulation and
also ageing process may inuence plastic materials.
This checking is necessary for both xed installations and preparing xtures for renting. Any free moving parts
inside of the xture head, cracked plastic or any plastic part of front lens not sitting properly in place need to
be immediately replaced.
11.1 Disposing of the product
To preserve the environment please dispose or recycle this product at the end of its life according to the local
regulations and codes.