Operating your clock radio
1. Press the On / Off control to switch on your clock radio. (see page 7).
When fi rst switched on, the clock radio will be in DAB mode. After each
use the clock radio will remember the mode used and then switch on
in that mode the next time that it is used.
2. If the radio has been used before, the last used station will be selected.
3. If this is the fi rst time that the clock radio has been used a scan of
the Band III DAB channels will be carried out (depending on whether
scanning was already completed in Standby mode). During the
scanning process the display will show progress of the station search.
The number on the right of the display is the number of stations that
have been found.
4. When the scan is completed the fi rst station (in numeric-alpha order
0....9, A....Z) will be selected. The fi rst station in the list of stations
found during scanning will be played. The display will show the station
name.
5. If no signals are found then 'OFF AIR' will be displayed and it may
be necessary to relocate your clock radio to a position giving better
reception. You should then carry out a scan to fi nd stations as described
on page 12.
Note: When fi rst switched on the radio will set the volume to a moderately
high level in case the broadcast is very quiet. After you have set the volume
using the Volume control (see page 7) the radio will remember the setting
that you have applied for the next time that it is used.
1
8
To Next Page
Loading...
