Robin RGD500 - Page 45

(3) Fix the rear cover to the adapter with four
bolts, spring washer, and washer.
6@x25mmbolt
... 4pcs.
6 @ washer. . .4 pcs.
6 @ spring washer. . .4 pcs.
I Tightening torque I
~
4.5 - 5.9 N-m
50 - 60 k-
3.6 - 4.3 ft-lb
10-4-5 RECOIL STARTER
(1) Remove the through bolt which has been ten-
tatively
attached to the rotor.
(2) Insert the key into the keyway of the rotor
shaft.(See Fig. 10-33.)
Then, insert the spacer.
Tapping the starter pulley
with a plastic ham-
mer,
attach the starter pulley to the rotor shaft.
Fig. 70-33
(3) Apply a washer and a spring washer to the through bolt and insert it into the rotor shaft.
Through bolt . - . 1 pce.
10 @ washer . . .1 pce.
10 @ spring washer. . .1 pce.
"The dimension of the through bolt is shown in Table 10-2.
L
t-
m 1
I
Model lZISldl
I I
Table. 10-2
- 42-