RoboBuilder UXA-90 Light - Page 7

Reatorm Defaults
<Figure 3>
3) Click on the Advanced button in the port settings.
OK
rtr C
USB Transfer Sizes . Canud
Select
lower settings to correct performance problems at low baud rates,
I
OefeL4j
Select higher
settings for footer performance.
Receive
(Bytes)
koWr
-1
(Bytes) -
1d09
-J
BM Options
Miscellaneous Options
Select lower settings to correct response problems.
Serial Enumerator
Serial Printer
Timer (insec)
It.
'.'j
E
Latency
Cancel If Power Off
L M
Event On Surprise Removal
E l-
Tmeouts
Set RTS On Clone
C
Disable Modem Ctrl Al Startup
C
Minimum Read Timeout (msec)r
[o
I
Enable Selectee Suspend
Minimum
Write Timeout (rosec);
0
Selectee Suspend Sille Timeout (secs);
<Figure 5>
5) Change the COM Port Number to [COM3], and Latency Timer (msec) to [1].
-
7