Robustel GoRugged R3000 - Interface->Link Manager

Robustel GoRugged R3000 User Guide
RT_UG_R3000_v.3.0.3 04.02.2017 34 / 124
Confidential
Router Information
Item
Description
IP Address
Show the current IP Address and the Netmask.
MAC Address
Show the current MAC Address.
3.6 Interface->Link Manager
Link Manager
User can manage the link connection in this section. R3000 support Cellular, Ethernet and Wi-Fi link connection.
Link Manager
Item
Description
Default
Primary Link
Select from “WWAN1”, “WWAN2”, “WAN”.
1. WWAN1: Select to make SIM1 as the primary wireless link.
Note: insert SIM card please refer to the installation quick guide.
2. WWAN2: Select to make SIM2 as the primary wireless link.
3. WAN: Select to make WAN Ethernet port as the primary link.
Note: WAN link available only if enable ETH0 as WAN interface in
System->Device Configuration->Advance Device Settings
WWAN1
Backup Link
Select from “None”, “WWAN1”, “WWAN2”, “WAN”.
1. None: Do not select backup interface.
2. WWAN1: Select to make SIM1 as backup wireless WAN.
3. WWAN2: Select to make SIM2 as backup wireless WAN.
4. WAN: Select to make WAN Ethernet port as the backup WAN.
Note: WAN link available only if enable ETH0 as WAN interface in
System->Device Configuration->Advance Device Settings
None
Backup Mode
Cold backup: The inactive link is offline on standby.
Warm backup: The inactive link is online on standby.
Warm backup mode is not available for dual SIM backup.
Cold
backup
Emergency Reboot
Enable to reboot the whole system if no links available.
OFF
Note: Click“ ” for help.
Link Setting section allows user to configure the parameter of link connection, include the WWAN1/WWAN, WAN