Robustel GoRugged R3000 - Interface->USB

Robustel GoRugged R3000 User Guide
RT_UG_R3000_v.3.0.3 04.02.2017 50 / 124
Confidential
Status
Item
Description
Modem Status
Show the status of the radio module.
Current SIM
Show the SIM card which the router works with currently: SIM1 or SIM2.
Total SIMs
Show the number of SIM cards that is installed in the router.
Phone Number
Show the phone number of the current SIM.
IMSI
Show the IMSI number of the current SIM.
ICCID
Show the ICCID number of the current SIM.
Network Registration
Show the current network status.
Network Operator
Show the name of Network Provider.
Network Type
Show the current network service type, e.g. GPRS.
Signal Strength
Show the current signal strength.
Cell ID
Show the current cell ID, which can locate the router.
Model
Show the model of the radio module.
IMEI
Show the IMEI number of the radio module.
Firmware Version
Show the current firmware version of the radio module.
3.10 Interface->USB
This section allows users to set the USB parameters.
Note: Users can insert a USB storage device, such as U disk and hard disk, into the router’s USB interface. If there is
firmware of R3000 inside the USB storage devices, R3000 will automatically update the firmware. We will provide
another file “application note” to show how to do USB automatic update.
USB
Item
Description
Default
Enable USB
Click to enable USB feature.
ON
Enable Automatic
Firmware Updating
Click Enable to automatically update the firmware of R3000 when insert the
USB storage devices which has R3000’s firmware.
ON
R3000 has the key for USB automatic update. User can generate the key in this page.
Click , it will generate a key below. Click to download the key.