Robustel GoRugged R3000 - Network -> Qos

Robustel GoRugged R3000 User Guide
RT_UG_R3000_v.3.0.3 04.02.2017 61 / 124
Confidential
3.15 Network -> QoS
This section allows users to set the QoS parameters.
Please remember to set QoS upload and download bandwidth in the Interface->Link Manager WWAN/WAN
before Configure Qos parameters.
Select the priority, click to enter the priority definition configuration window.
QoS
Item
Description
Default
Enable QoS
Click to enable “QoS” function.
Disable
Index
Show the index of priority.
/
Priority
Select from “Highest”, “High”, “Normal”, “Low”, “Lowest”.
User can select the priority level according to the requirement.
/
Bandwidth
Define bandwidth percent of “Highest”, “High”, “Normal”, “Low” and
“Lowest”.
All the bandwidth percent of priority are defaulted to 20%.
User can configure the bandwidth percent of priority according to the
requirement. The sum of bandwidth of all the priorities cannot be greater
than 100%.
20
Borrow Spare
The traffic associated with this priority will borrow unused bandwidth from
ON